Step B09.4 — Load plate B09-P2¶
Step 4 of 13 with a helper · Batch B09 — Panels, filtration, spool
Gather for this segment — steps B09.4–B09.5 (~5 min)
Hardware
- both brims already in the project
Printed parts
Regular_Cartridge(3mf), 3 mm brim — from bin 11-nevermoreexhaust_cover, 3 mm brim — 4.9 h, 67 g (PrusaSlicer 2.9.6 estimate) — from bin 11-finish
Parts:
-
Regular_Cartridge(3mf), 3 mm brim -
exhaust_cover, 3 mm brim — 4.9 h, 67 g (PrusaSlicer 2.9.6 estimate) - both brims already in the project
Do: Open slicer/plates/B09-P2.3mf with File → Open Project. The arrangement, brims and overrides
are already in it. Leave the cartridge's built-in support in place.
Check
Cartridge support intact in preview; brim outline shows on both.
Helper Names the bin colour of each part on the sorting diagram while you open the project.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B09.13.
Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · Nevermore Micro README