Step B10.2 — Load plate B10-P1¶
Step 2 of 6 with a helper · Batch B10 — Clicky-Clack door
Parts:
-
Handle-Hinge_Bottom, no brim -
Handle-Hinge_Top, no brim -
Hinge-L-sleeve-2X×2, 5 mm brim already in the project -
Hinge-L-solid-2X×2, 5 mm brim -
Latch, 5 mm brim -
Panel_Clip, no brim - 6 files, 8 objects — 5.7 h, 76 g (PrusaSlicer 2.9.6 estimate)
Do: Open slicer/plates/B10-P1.3mf with File → Open Project; the arrangement, brims and overrides are already in it. Mirror the four Hinge-L-* objects in 2.9.6 only if the door must open the other way; the 3.0 preview has no mirror tool.
Check
The preview shows the brim outline on the four hinge parts and Latch, and on nothing else;
swing decision made before slicing, not after.
Helper Reads the sorting diagram legend aloud and counts the parts on it while you load.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B10.6.
Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · Clicky-Clack door README