Skip to content
Batch B101 / 6

Step B10.1 — Filament prep

Step 1 of 6 · Batch B10 — Clicky-Clack door

(no image — see text)

gather Gather for this segment — steps B10.1–B10.4 (~5 min)

Hardware

  • 6 files, 8 objects — 5.7 h, 76 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • Handle-Hinge_Bottom, no brim — from bin 11-door
  • Handle-Hinge_Top, no brim — from bin 11-door
  • Hinge-L-sleeve-2X, 5 mm brim already in the project ×2 — from bin 11-door
  • Hinge-L-solid-2X, 5 mm brim ×2 — from bin 11-door
  • Latch, 5 mm brim — from bin 11-door
  • Panel_Clip, no brim — from bin 11-door

Do: Galaxy Black, spool #3 after B09: the ledger has 530 g on it here and 454 g after, the last plate of the run. The blue Handle from B02 should already be set aside. Sheet per 00-slicer-setup § Print sheet.

check Check

Clean purge; ≥76 g on spool #3.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B10 — before you start

Next →Step B10.2 — Load plate B10-P1