Batch B10Checkpoint
Checkpoint B10¶
Checkpoint · Batch B10 — Clicky-Clack door
- (kit day) Split bushings tap into hinge sleeves without splitting the part
- (kit day) M5×45 dowel pin is a tight hammer fit into
Hinge-L-solid, ~20 mm proud - Door swing decided from where the machine will live (as designed: hinges left, opens from the right); hinge files mirrored only if it must open the other way
- Blue
Handle(B02) reunited with the black hardware for assembly
Common mistakes¶
- Mirroring the
Hinge-L-*parts "to be safe" — as designed the hinges are on the left; mirror only if the machine's left side will be against a wall. - Pressing the M5×45 dowel pin in loose instead of a tight hammer fit — the door will rack.
- Printing the stock Voron/LDO door parts alongside Clicky-Clack "just in case."
Next¶
Assembly: door hinges and handle in Ch 11 Part A (Steps 11.46–11.50), the door hung in Part B. Printing:
this is the last plate of the ASA run. All 22 are done and binned, weeks before the cartons land.
B11's P1–P3 (PETG V0) can print now; P4 and P5 wait for the kit-day bay measurements.
The only ASA job left is a deck_support_4mm reprint if the deck panel calipers 4 mm.