Skip to content
Batch B11 › Before kit1 / 14

Step B11.1 — Filament and sheet prep

Step 1 of 14 · Batch B11 — Bay ducting (PETG V0)

(no image — see text)

gather Gather for this segment — steps B11.1–B11.3 (~5 min)

Hardware

  • 2 files, 2 objects — 0.4 h, 4 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Printed parts

  • V3L_COUPON_22N_DUCT — from bin 09-ducts-DC
  • V3L_COUPON_22N_DUCT_COVER — from bin 09-ducts-DC

Do: Load the Prusament PETG V0 Jet Black spool, V1 in the ledger. A fresh sealed spool goes straight in; an opened one dries at 55 °C for 6 h. Fit the textured sheet.

check Check

Textured sheet on, clean purge, and at least 348 g on the spool for the whole batch.

Sheet

Prusa does not recommend PETG V0 on smooth PEI. It can bond hard enough to tear the coating, and the damage is not covered by warranty. Keep the smooth sheet for ASA. src

Source: print/README § B11 spool ledger · Prusament PETG V0 Jet Black · Prusa KB — PETG

← PreviousBatch B11 — before you start

Next →Step B11.2 — Pre-print checks