Skip to content
Batch B11 › After the kit-day measurements12 / 14

Step B11.12 — Load and print plate B11-P4

Step 12 of 14 · Batch B11 — Bay ducting (PETG V0)

gather Gather for this segment — step B11.12 (~5 min)

Hardware

  • 10 files, 18 objects — 6.3 h, 82 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Printed parts

  • V2L_58mm_DUCT ×3 — from bin 09-ducts-DC
  • V2L_58mm_DUCT_COVER ×3 — from bin 11-lids-DC
  • V2L_130mm_DUCT — from bin 09-ducts-DC
  • V2L_130mm_DUCT_COVER — from bin 11-lids-DC
  • V2L_70mm_DUCT — from bin 09-ducts-DC
  • V2L_70mm_DUCT_COVER — from bin 11-lids-DC
  • V3L_10mm_DUCT ×3 — from bin 09-ducts-DC, 09-ducts-AC
  • V3L_10mm_DUCT_COVER ×3 — from bin 11-lids-DC, 10-lids-AC
  • V3L_34mm_DUCT_HOLE — from bin 09-ducts-AC
  • V3L_34mm_DUCT_COVER — from bin 10-lids-AC

Parts:

  • V2L_58mm_DUCT ×3
  • V2L_58mm_DUCT_COVER ×3
  • V2L_130mm_DUCT
  • V2L_130mm_DUCT_COVER
  • V2L_70mm_DUCT
  • V2L_70mm_DUCT_COVER
  • V3L_10mm_DUCT ×3
  • V3L_10mm_DUCT_COVER ×3
  • V3L_34mm_DUCT_HOLE
  • V3L_34mm_DUCT_COVER
  • 10 files, 18 objects — 6.3 h, 82 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Do: Open slicer/plates/B11-P4.3mf with File → Open Project, after any regenerated piece is back on the plate. These are the custom lengths.

check Check

The plate holds the lengths the bay measured, and the 34 mm piece shows its floor opening.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B11.14.

tip Tip

Paused or stopped mid-plate? See When the printer stops.

pause Good stopping point · ~5 min since the last one

plate B11-P4 running, 6.3 h unattended.

Source: print plan §3 — the batches · review/2026-09-23-bay-mods/layout-v3/layout-v3.md

← PreviousStep B11.11 — Regenerate a piece whose gap differs

Next →Step B11.13 — Load and print plate B11-P5