Step B11.13 — Load and print plate B11-P5¶
Step 13 of 14 · Batch B11 — Bay ducting (PETG V0)
Gather for this segment — step B11.13 (~5 min)
Hardware
- 4 files, 8 objects — 6.8 h, 93 g (PrusaSlicer 2.9.6 estimate)
- no brim
Printed parts
V3L_154N_DUCT×2 — from bin 09-ducts-DCV3L_154N_DUCT_COVER×2 — from bin 11-lids-DCV3L_T_REG_N×2 — from bin 09-ducts-DCV3L_T_REG_N_COVER×2 — from bin 11-lids-DC
Parts:
-
V3L_154N_DUCT×2 -
V3L_154N_DUCT_COVER×2 -
V3L_T_REG_N×2 -
V3L_T_REG_N_COVER×2 - 4 files, 8 objects — 6.8 h, 93 g (PrusaSlicer 2.9.6 estimate)
- no brim
Do: Print this plate only if the coupon passed and the gap measured 25 mm or more. Otherwise print the fallback listed under Options instead.
Check
Both narrowed 154s and both narrowed Ts base down, lids flat.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B11.14.
Fallback
stock CMD_V3_1H_T_REG and CMD_V3_1H_82mm_DUCT are drawn base up. Load them with slicer/bay-ducts-petg.ini, place each on its wide flat base, and print their covers as they come.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate B11-P5 or the fallback running.
Source: review/2026-09-23-bay-mods/layout-v3/layout-v3.md § Middle run · print plan §3 — the batches