Step B11.8 — Sort into bins¶
Step 8 of 14 with a helper · Batch B11 — Bay ducting (PETG V0)
(no image — see text)
Do: Sort off the plate diagrams: number to legend, colour to bin, bin id on the part. Mark plate id and date on a hidden face. Labels. Bodies to 09-ducts-DC or 09-ducts-AC; lids to 10-lids-AC or 11-lids-DC; fin to 10-lids-AC.
Check
9 pieces in 09-ducts-DC, 6 in 09-ducts-AC, 5 in 10-lids-AC with the strip fin, 7 in 11-lids-DC.
Helper Reads each bin label aloud and checks the count against the diagram.
B11-P1
| bin | parts off this plate |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | V3L_COUPON_22N_DUCT, V3L_COUPON_22N_DUCT_COVER |
B11-P2
| bin | parts off this plate |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | CMD_V3_1H_154mm_DUCT ×2, CMD_V3_1H_90DEG ×2, V2L_90DEG_MIRROR |
| 11-lids-DC — DC lids, B11 | CMD_V2_6B_154mm_DUCT_COVER ×2, CMD_V2_6B_90DEG_COVER ×2, V2L_90DEG_COVER_MIRROR |
B11-P3
| bin | parts off this plate |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | CMD_Remix-V3_DUCT-2B_45deg ×2 |
| 09-ducts-AC — AC conduit, B11 | V3L_WIRE_BOX_PORT, V3L_90DEG_R15 ×2, CMD_V3_1H_T_SHORT, CMD_Remix-V3_DUCT-1M_ENDCAP ×2 |
| 10-lids-AC — AC lids + strip fin, B11 | CMD_V2_6B_WIRE_BOX_COVER, V3L_90DEG_R15_COVER ×2, CMD_V2_6B_T_SHORT_COVER, V2L_STRIP_FIN |
| 11-lids-DC — DC lids, B11 | CMD_Remix-V3_DUCT-2B_45deg_LID ×2 |
Before the next ASA plate
smooth sheet back on, and Settings → Chamber Filtration reads Adv. Filtration. On None the AFS blower never runs and ASA vents unfiltered.
Good stopping point · ~10 min since the last one
the before-kit half of B11 is binned. Swap the smooth sheet back on and set Adv. Filtration if an ASA plate is next.