Step 00.23 — Print guidelines (p.4)¶
Step 23 of 32 pre-kit · Chapter 00 — Before you start
Tap to enlarge
Gather for this segment — steps 00.23–00.29 (~25 min)
Tools and consumables
- ball-end hex driver 2 mm
- ball-end hex driver 2.5 mm
- ball-end hex driver 3 mm
- plain hex driver 2.5 mm
Parts: none.
Do:
- Read the spec: ABS/ASA, 0.2 mm layers, forced 0.4 mm extrusion width, 4 perimeters, 5 solid top and bottom layers, 40% infill in grid, gyroid, honeycomb, triangle or cubic.
- Ignore the Print It Forward box.
Check
Nothing to do on the bench. If your slicer profile disagrees with this page, the profile is wrong.
What you're looking at
Manual p.4, the Voron print specification. These are the numbers the parts in this build are designed around: ABS or ASA, 0.2 mm layers, 4 perimeters, 5 solid top and bottom layers, 40 % infill. You print every part yourself.
Tip
_x4 means four, regardless of how many bodies are in the file.
Tip
The infill spec makes parts stiff enough to hold a bearing and stable in a 60 °C chamber.
Source: Voron manual p.4 · slicer setup