Step 02.23 — Check the shaft position against the section view¶
Step 23 of 44 with a helper · Chapter 02 — Z drives, Z idlers, Z rails, deck panel
Tap to enlarge
Parts: none.
Do: Hold your part next to the isometric and section views. Confirm the 20T pulley is on the same side, the spacer stack sits between the same two bearings, and the shaft ends are flush the same way.
Check
Your assembly and the drawing are indistinguishable. Fix it now: after the main goes on, six M3×40 have to come back out.
Helper Holds the drive beside the page and names any difference from the section view.
What you're looking at
Manual p.35's section view beside your part. The section is the only place the manual shows which side of the 20T pulley each spacer and bearing belongs on: after the main goes on, six long screws have to come back out to fix it.
Source: Voron manual p.35