Step 05.26 — Start the right XY joint bearing stack¶
Step 26 of 48 · Chapter 05 — Gantry: X and Y axes, XY joints, X carriage, titanium backers
Tap to enlarge
Parts:
-
xy_joint_right_upper_MGN12×1 · bin 05-XY - M5×40 SHCS ×1 · Fasteners, Tools & Misc box
- F695 bearing ×2 · Motion box
- M5 precision spacer ×2 · Fasteners, Tools & Misc box
Do:
- Keep the right-hand joint's moulded cable path clear and pointing as the page shows.
- Push an M5×40 SHCS up through the upper plate.
- Thread on bottom to top: spacer, F695 flange down, F695 flange up, spacer.
Check
Four items on the bolt, reading spacer, flange, plain, plain, flange, spacer from the side; bearings spin freely, cable channel clear.
What you're looking at
The two upper plates, left and right, carry the same tell as the lower bodies: the right-hand plate has the endstop wire channel. The stack you build on the M5×40 is the belt corner: two F695 flanged bearings, flange-out, between two brass precision spacers.
Caution
Rev D+ / LDO: the manual's "M5 Shim" is the brass M5 precision spacer in this kit, here and everywhere else unless a page is explicitly noted otherwise. src
Source: Voron manual p.97 · LDO Build Notes § Voron 2.4 build FAQ · Video: Part 3 @1:27:47 (differs: pre-release kit had no titanium rail backers)