Step 07.11 — A belt: run rearward up the left Y extrusion¶
Step 11 of 39 · Chapter 07 — A/B belts and tensioning
Tap to enlarge
Parts:
- the A belt · already on the bench
Do: Run the belt straight back along the left Y extrusion to the rear-left drive unit. This is the single run on the left side of the machine, the p.126 top-left inset.
Check
The run is parallel to the extrusion along its whole length and clears the printed parts and the Z belt.
What you're looking at
The single long run down the left-hand side of the machine. Nothing turns the belt here, so the only things to get right are that it stays parallel to the extrusion and clears every printed part on the way.
Source: Voron manual p.126