Skip to content
Ch 08 › D — Stealthburner body: LEDs and fans35 / 65

Step 08.35 — Build the logo LED into its carrier

Step 35 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2

Full page

Tap to enlarge

Parts:

  • [o]_stealthburner_LED_carrier ×1 · bin 08-SB
  • [o]_stealthburner_LED_diffuser_mask ×1 · bin 08-SB
  • Stealthburner LED Diffuser, clear PETG ×1 · Electronics 2 box
  • logo LED, chain index 1 ×1 · the LDO kit, no BOM row

Do:

  1. Seat the logo LED in the carrier, wires exiting upwards.
  2. Stack from the outside in: opaque mask, then diffuser with its prongs forward and flat base behind, then the LED carrier. SB p.47 right draws the result.

check Check

Three translucent bars sit flush in the black face, the diffuser's flat base behind the mask and not in front. Nothing rattles.

What you're looking at

The logo LED and its three-part sandwich, from the outside in: the opaque mask with three windows is the face you see; the clear PETG diffuser behind it pokes three prongs forward through those windows; the carrier holds the LED behind both.

Source: SB manual p.47

← PreviousStep 08.34 — Prepare the 5015 part-cooling blower

Next →Step 08.36 — Wire the three-LED chain