Step 08.37 — Seat the two toolhead LEDs¶
Step 37 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Tap to enlarge
Gather for this segment — steps 08.37–08.42 (~20 min)
Fasteners, Tools & Misc box
- M3×6 FHCS ×2
Belts, Chains & Fans box
- 40×40×10 axial fan, 24 V ×1
- 50×50×15 centrifugal fan, trimmed ×1
Already on the bench
- the two toolhead LEDs on their chain
- the Stealthburner main body
- the logo LED stack, mask with diffuser and the LED carrier
- the LED chain in the body
- the hotend fan's leads
Parts:
- the two toolhead LEDs on their chain · already on the bench
- the Stealthburner main body · already on the bench
Do: Push each toolhead LED into its pocket in the top corners of the main body, from the outside inwards, wires trailing outboard. p.48 is drawn from behind: its RIGHT pocket is index 2, its LEFT pocket index 3.
Check
Both LEDs bottom in their pockets and face down into the print area.
What you're looking at
The two toolhead LEDs sit in the top corners of the body and light the print area from above. SB p.48 names them from behind: index 2 is the toolhead's own right, the pocket on your left when you face the printer.
Source: SB manual p.48