Step 08.39 — Route the LED wires out of the body¶
Step 39 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Tap to enlarge
Parts:
- the LED chain in the body · already on the bench
Do: Lay the LED wires into the moulded channels so the whole harness exits on the right side of the body. Keep them out of the fan cavities.
Check
With the body face-down, no wire crosses either fan opening and the harness leaves as a single bundle on the right.
What you're looking at
Every wire in the body is routed to leave on one side, so the whole harness can be taken to the fan adapter as a single bundle. A wire crossing a fan opening is a wire an impeller will eventually find.
Source: SB manual p.51