Step 08.44 — Mount the fan adapter PCB on the back of the 5015¶
Step 44 of 65 · Chapter 08 — Toolhead: Stealthburner, Clockwork 2, Revo HF, Nitehawk-SB V2
Parts:
- Stealthburner Fan Adapter PCB (SBurnerFanAdapter_V2.0) ×1 · Electronics 2 box
- M3×10 FHCS ×2 · Fasteners, Tools & Misc box
Do: Mount the adapter to the rear of the Stealthburner main body, onto the back of the 5015 fan, with two M3×10 FHCS through its end holes. Whether these share or replace the M3×6 FHCS from 08.42 is undrawn (verify on bench; no LDO photo of the mounted adapter has been found).
Check
Board flat against the fan; its P1 header points at the toolboard's header when the body is offered up.
What you're looking at
The fan adapter is the PCB that collects both fans and the LED chain on the body side and hands them to the toolboard through a single board-to-board header, so the blue body lifts off with three plugs still made up.
Source: SB V2 fan adapter pinout
