Ch 0912 / 36
Step 09.12 — Mount the inlet panel to the rear extrusion¶
Step 12 of 36 · Chapter 09 — Electronics bay
Tap to enlarge
Parts:
- M3×8 SHCS ×2 · Fasteners, Tools & Misc box
- the two pre-loaded rear M3 T-nuts · already on the bench
Do:
- Hook the panel's lip over the rear extrusion's slot and start two M3×8 SHCS into the T-nuts, loose.
- Slide it against the rear-left Z-motor mount, then tighten. The WAGO block goes to its right.
Check
Panel flat against the extrusion, no gap at the lip, no overhang where the rear skirt lands in Ch 11, inlet reachable from outside.
What you're looking at
The panel hooks over the rear extrusion's slot and bolts to the two T-nuts from Step 09.3. Position matters twice: hard against the Z-motor mount so the rear skirt segments line up, and inside the footprint where the rear skirt lands in Ch 11.
Source: Voron manual p.167 · LDO wiring guide § Preparing the inlet · Video: Part 7 @0:59:57