Step 09.31 — Do not build the soldered X/Y microswitches¶
Step 31 of 36 · Chapter 09 — Electronics bay
Tap to enlarge
Gather for this segment — steps 09.31–09.34 (~25 min)
Electronics 1 box
- WAGO 221-412 (2-way) ×2
Electronics 2 box
- XY endstop PCB ×1
- Bed WAGO Mount (LDO-supplied printed) ×1
- 2×2 XH splicer PCB ×1
Fasteners, Tools & Misc box
- M3×8 SHCS ×2
- M3×30 SHCS ×2
- M3×5×4 heat-set inserts ×2
- M3×6 BHCS ×2
- M5×10 BHCS ×2
- M5 T-nut (verify on bench) ×2
Printed parts
[a]_endstop_pod_D2F_switch×1 · bin 05-XY
Already on the bench
- the pod assembly
Parts: none.
Do: Skip the page. No wire is cut, stripped or soldered here.
Check
Your XY endstop is one PCB with one 4-pin JST-XH connector, not two loose microswitches with flying leads.
What you're looking at
A skip. The manual builds its XY endstops from two loose microswitches with soldered flying leads; this kit ships them as one small PCB with a single 4-pin connector, so there is nothing to cut, strip or solder.
Caution
Rev D+ / LDO: SKIP manual p.162 — "The kit uses the X/Y Endstop PCB board." Also skip the hall-effect option on p.163: this kit has no hall-effect endstops anywhere (LDO note on p.145). src
Source: Voron manual p.162 · LDO Build Notes § Voron 2.4 build FAQ