Step 09.33 — Mount the endstop pod to the gantry¶
Step 33 of 36 with a helper · Chapter 09 — Electronics bay
Tap to enlarge
Parts:
- the pod assembly · already on the bench
- M3×30 SHCS ×2 · Fasteners, Tools & Misc box
Do: Hold the pod against the underside of the right-hand XY joint, facing up with the printer inverted. Drive the two M3×30 SHCS bagged with it at 05.46 through it into the joint's two free holes.
Check
Pod solid with no rotation. Through full X and Y travel it fouls nothing: frame, Z rail, chain or toolhead.
Helper Watches the pod while the adult moves the toolhead through X and Y, and calls out any touch.
What you're looking at
The pod bolts up into the right-hand XY joint on two M3×30 SHCS, long enough to pass through the pod body; the M3×16 of p.106 cannot reach the joint through it. With the printer inverted the joint's underside faces up.
Source: Voron manual p.164 · LDO Build Notes § Voron 2.4 build FAQ · Video: Part 6 @1:30:12