Step 10.49 — LED strip → LED-Strip¶
Step 49 of 80 · Chapter 10 — Wiring and Checkpoint #1
Parts:
- the LED STRIP cable from the junction PCB · already on the bench
Do: Plug the lead from the ceiling junction PCB into the Leviathan port silkscreened LED-Strip, pin PE6.
Check
LED-Strip, not Neopixel. LED-Strip is a dimmable 350 mA constant-current output; Neopixel is data. The Stealthburner LEDs are addressable and hang off the toolboard, not this port.
What you're looking at
LED-Strip is a dimmable constant-current output that powers plain LEDs directly, up to 350 mA. The Neopixel header next to it instead sends a data signal to addressable LEDs; that is what the Stealthburner logo uses, and it runs from the toolboard, not from here.
Source: LDO Rev D photo S7 fan/LED mapping · LDO wiring guide § Connecting the fans and the LED strip · LDO Leviathan V1.3 guide (manual p.5)
