Step 10.55 — Connector types on the V2 toolboard¶
Step 55 of 80 · Chapter 10 — Wiring and Checkpoint #1
Parts: none.
Do: Before you touch anything on the toolhead, confirm what Ch 08 fitted:
Check
The probe, hotend-thermistor and endstop plugs are the small PH2.0 housings. The extruder motor stays XH2.5 and the umbilical stays XT30.
What you're looking at
The Nitehawk-SB V2 is the toolboard: the small PCB on the toolhead driving the hotend, fans, LEDs, probe and accelerometer, so only one cable crosses the moving gantry. V2 uses the finer JST-PH2.0 housings where the Rev D guide still names the coarser XH2.5.
| Port | Rev D wiring guide says | Rev D+ / Nitehawk V2 actually is |
|---|---|---|
PROBE |
not specified | JST-PH2.0 3P, 24 V only |
TH0 (hotend thermistor) |
"JST-XH2.5 two pin" | JST-PH2.0 2P, 2.2 kΩ pull-up |
Endstop (X/Y) |
not specified — only "the endstop port isn't used in a standard Rev D build" | JST-PH2.0 4P — unused in a standard build |
HE0 (hotend heater) |
screw terminal / E0508 ferrule | unchanged |
TH0 is the one real conflict: JST-XH2.5 is the only connector the Rev D guide names for the toolhead, and for the SB fans it names JST-PH2.0.
Caution
Rev D+ / LDO: the Rev D wiring guide has not been updated for this. Trust the V2 board doc. src — survey §4.1 ③
Source: Nitehawk-SB-V2 repo nhsbv2_pcb_pinout.jpg · Nitehawk-SB V2 doc § Connector variants — toolboard side · Nitehawk-SB V2 README § Change list from Nitehawk-SB V1 · Video: More Extras! @2:00:45 (differs: no toolboard — loom to the mainboard; this kit runs a Nitehawk-SB V2 on one USB+24 V umbilical)
