Step 11.17 — Mount the second side skirt run¶
Step 18 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Parts:
-
side_skirt_a_350×1 · bin 11-skirts -
side_skirt_b_350×1 · bin 11-skirts - the left-hand fan support with its retainers · already on the bench
- M3×8 SHCS ×2 · Fasteners, Tools & Misc box
- M5×10 BHCS ×1 · Fasteners, Tools & Misc box
- this side's three T-nuts · already on the bench
Do: Repeat 11.15 and 11.16 on the left-hand side with the retainer support. p.229 shows the T-nuts, p.230 the fasteners.
Check
The ring closed all the way round, every joint tight, every top rail flush. Two fans right, two retainers left.
Helper Holds the left fan support in its gap while you close the run.
What you're looking at
The same three-segment run on the left-hand side. Its middle segment is the second side_fan_support, no fans in it, just grills on the two retainers from 11.11. When it closes, the skirt ring is continuous all the way round.
Good stopping point · ~20 min since the last one
front, rear and both side skirt runs mounted, both bay fans in the right-hand run, grills on retainers in the left. The ring is complete all the way round; no run is half-fastened.
Source: Voron manual p.229 · Voron manual p.230