Step 11.22 — Choose the Z belt cover variant¶
Step 23 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Tap to enlarge
Gather for this segment — steps 11.22–11.25 (~15 min)
Fasteners, Tools & Misc box
- M3 hammerhead T-nut ×4
- M3×6 BHCS ×4
Printed parts
z_belt_cover_a×2 · bin 11-panelsz_belt_cover_b×2 · bin 11-panels
Already on the bench
- the four Z belt covers
- one loaded Z belt cover
- the three remaining loaded covers
Parts:
-
z_belt_cover_a×2 · bin 11-panels -
z_belt_cover_b×2 · bin 11-panels
Do: Check how Ch 10 routed the chamber LED wiring. Ch 10 used the extrusion slot, so the stock covers apply. If any LED wire passes through a Z-motor opening, print LDO's z_belt_cover_a_led for that corner, a 7 g, 25-minute part.
Check
You can state, per corner, which cover goes on and why. No cable crosses a stock cover's sealing face.
What you're looking at
A Z belt cover is a printed shroud that clips over each of the four Z belts at a frame corner, so nothing can be drawn into the belt. LDO's alternate _a_led version adds a cable slot for LED wiring routed through a Z-motor opening.
Caution
Rev D+ / LDO: "PAGE 234 Use the alternate Z-belt cover if you routed the LED wires through the Z-motor opening." src · part
Source: Voron manual p.234 · LDO Build Notes p.234 · LDOVoron2 z_belt_cover_a_led.stl