Step 11.32 — Bolt the fans to the plenum¶
Step 33 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see LDO Nevermore guide § Install Fans)
Parts:
- M3×16 BHCS ×4 · the Nevermore parts bag
- the two Nevermore fans · already on the bench
Do: Drive the four M3×16 BHCS into the fan heat-sets from 11.28. Snug only; a 5015 housing distorts and the impeller rubs if you crank them.
Check
Both fans held with no rock; spin each impeller by hand and listen for rub.
What you're looking at
The M3×16 BHCS pass through the fan bodies into the heat-sets from 11.28. A 5015 housing is thin plastic and will distort if these are cranked, which shows up as the impeller rubbing.