Step 11.34 — Glue the plenum magnets¶
Step 35 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see LDO Nevermore guide § Nevermore Assembly)
Gather for this segment — steps 11.34–11.37 (~20 min)
Fasteners, Tools & Misc box
- 6×3 mm neodymium magnet ×8
- M3×6 BHCS ×2
Printed parts
V2_Duo_Plenum_LID×1 · bin 11-nevermoreRegular_Cartridge_Lid×1 · bin 11-nevermore
Tools and consumables
- super glue
- a marker
- 4 mm acid-free activated carbon pellets, not supplied
Parts:
- 6×3 mm neodymium magnet ×4 · Fasteners, Tools & Misc box
- super glue · consumable
Do: Drop a spot of super glue into each of the plenum's four magnet pockets and press a magnet in, one at a time, all with the same pole facing out. Press each fully home.
Check
All four plenum magnets flush and the same polarity: a spare magnet is attracted to every one the same way.
Helper Tests each magnet against a spare and hands them over all the same side up.
What you're looking at
The plenum and cartridge hold together on magnets rather than screws, so the cartridge can be pulled off to recharge the carbon. Every magnet in the plenum must go in with the same pole facing out, otherwise half of them will repel the cartridge.
Source: LDO Nevermore V5 Duo guide § Nevermore Assembly · Video: Extras! @2:59:56