Step 11.35 — Close the plenum lid¶
Step 36 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see LDO Nevermore guide § Nevermore Assembly)
Parts:
-
V2_Duo_Plenum_LID×1 · bin 11-nevermore - M3×6 BHCS ×1 · Fasteners, Tools & Misc box
Do: Slide the lid into the plenum body's grooves and secure with the M3×6 BHCS into the plenum heat-set. Add the optional M3×4 on the other side if you want it to look symmetric.
Check
Lid fully home in both grooves, screw snug, no wire pinched at the lid edge.
What you're looking at
The lid slides into grooves in the plenum body and one screw holds it. It closes the fan compartment so the blowers push air through the cartridge rather than straight back out.