Step 11.49 — Fit the latch's heat-set and panel clip¶
Step 50 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see KB3D guide § Hinge & Handle Assembly)
Parts:
- the latch · already on the bench
- M3×5×4 heat-set insert ×1 · Clicky-Clack door kit
-
Panel_Clip×1 · bin 11-door - M3×8 BHCS ×1 · Clicky-Clack door kit
Do: Press one heat-set insert into the hole in the middle of the latch and let it cool. Then screw the Panel_Clip onto the latch with the M3×8 BHCS.
Check
Insert square and flush; the panel clip is solid on the latch and its panel groove is unobstructed.
What you're looking at
The Panel_Clip is both the door's catch and the middle side-panel clip for that side, so one of the eight clips fitted at 11.57 is displaced by it at 11.63. The heat-set gives the latch a metal thread.
Source: KB3D Clicky-Clack install guide § Hinge & Handle Assembly