Step 11.50 — Finish the handle¶
Step 51 of 67 · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
(no image — see mod README § Assembly)
Parts:
- the handle and both handle hinges · already on the bench
- M5×45 dowel pin ×2 · Clicky-Clack door kit
- M5×7×8 split bushing ×2 · Clicky-Clack door kit
- M3×8 SHCS ×2 · Clicky-Clack door kit
Do:
- Push the two M5×45 pins into the handle, looser than the door hinges.
- Tap one bushing into each handle hinge.
- Drive the two M3×8 locating screws into the handle ends, then slide the hinges on.
Check
Handle hinges slide on and stay put by magnet alone; the handle rotates through its full arc and stops against the locating screws; nothing binds.
What you're looking at
The handle hangs on two more M5×45 pins, deliberately looser than the door hinges so it can swing. The two M3×8 screws at its ends are travel stops, not fasteners: they limit how far the handle rotates.