Step 11.55 — Hang the back panel¶
Step 56 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Tap to enlarge
Parts:
- back panel, acrylic, black, 483×503×3 mm ×1 · Panel Kit box (carton 2)
- M5 roll-in T-nut ×2 · Fasteners, Tools & Misc box
- M5×10 BHCS ×2 · Fasteners, Tools & Misc box
- the back-panel clips, exhaust cover and grill · already on the bench
- the reverse-bowden PTFE · already on the bench
Do:
- Roll two M5 T-nuts into the top rear extrusion's back slot, one per cover tab.
- Hang the panel; clips tight, opposite corners first; one M5×10 BHCS per tab.
- Re-route the PTFE in through the cover's coupler.
Check
Panel square and flat, foam compressed but not squashed, both tabs tight on the extrusion, and the PTFE sliding through the coupler without a kink.
Helper Holds the panel square in the clips while you tighten opposite corners.
What you're looking at
Everything from 11.52 to 11.54 goes on as one assembly; the cover's two tabs bolt into the top rear extrusion's back slot, where p.255 puts the mounts. Opposite corners first keeps the acrylic flat. The PTFE then loops into the cover's coupler, as on p.258.
Good stopping point · ~25 min since the last one
back panel foam-taped, its seven clips on, exhaust cover and grill sealed into the cut-out, panel hung and screwed down, cover tabs bolted, the PTFE through the cover's coupler. A panel is either fully clipped or off the machine — never leave one hanging on half its clips.
Source: Voron manual p.240 · Voron manual p.255 · Voron manual p.258 · LDOVoron2 exhaust_cover.stl