Step 11.61 — Do not fit the stock doors¶
Step 62 of 67 with a helper · Chapter 11 — Skirts, panels, Clicky-Clack door, filtration
Tap to enlarge
Parts: none.
Do:
- Skip all five DOORS pages, p.245 to p.249; the Clicky-Clack replaces them.
- Confirm you never printed
door_hinge_x6,handle_a_x2,handle_b_x2,latch_x2or LDO'sLDO Door/set. - Bag the two stock door panels and the spare magnets.
Check
No stock door hardware installed; the front opening is bare extrusion with the 3 mm foam gasket from 11.51 on it.
Helper Bags the two stock door panels and the spare magnets and labels the bag.
What you're looking at
The five pages show the stock Voron front: two narrow hinged doors, magnets glued into the front extrusions, printed handles and latches. The Clicky-Clack replaces all of it with one framed door, so nothing here is fitted and the two supplied door panels become spares.
Caution
Fitting Clicky-Clack means you also lose LDO's kit-number nameplate, which lives on LDO Door/handle_b_nameplate.stl. Print it and glue it elsewhere if you want it (print plan §3, B10).
Good stopping point · ~15 min since the last one
top panel on its eight clips, handlebars bolted through their spacers, and the stock front doors confirmed not-installed. The machine is closed on five faces; the front is still open.