Step 13.47 — Decide what to print, or stop¶
Step 47 of 54 with a helper · Chapter 13 — Initial startup
(no image — see text)
Parts:
- the laptop with this repo and its
venv-cqPython · tool
Do:
- Fill in the calculator below. A failing row stops here or drops the stop bracket.
- Run the generator with your five numbers and keep its printout.
- Shut the Voron down as before.
venv-cq/bin/python slicer/addons/scrubber-796563/remix.py --H 20.05 --w 3.85 --d 0.6 --G 20.65 --O 4.5
Scrubber add-on — does it fit, and which parts — the calculator needs JavaScript; the limits are in the table on this page.
Check
The generator printed L, T and a sheet-stop line and wrote three files to measured/, or printed NO-GO and wrote nothing.
Helper Reads each number off the record card while the adult types it in.
What you're looking at
The calculator checks the layout numbers. The generator works the heights out from yours: how far to lower the wiper seat, how much to trim the bucket, and whether the sheet-stop screws fit. It can also say no-go.
Caution
NO-GO means the add-on stays off and every step below is skipped. The files committed beside the generator are only its default for the expected numbers: print the set it writes for yours.
Good stopping point · ~35 min since the last one
H, w, d, G and O measured and written down, the decision made, the chosen files in measured/ or NO-GO recorded, and the Voron shut down as at Step 13.43. Nothing printed yet.
Source: slicer/addons/scrubber-796563/README.md and remix.py · Printables 796563 — STEP files and height notes