Step 14.32 — Close the bay and power on, hand on the switch¶
Step 32 of 36 · Chapter 14 — Calibration and tuning
(no image — see text)
Parts: none.
Do:
- Close the bottom panel, stand the machine upright, cord back in.
- Power on with a hand on the rocker, as at 13.3.
Check
Klipper Ready with both MCUs, no smell or smoke, and the exhaust fan still: nothing drives FAN0 yet.
What you're looking at
The first power-on after the bay was open repeats Ch 13's ritual: a hand on the rocker and eyes on the board. A new lead and a third jumper are the only changes since the last good boot.
Good stopping point · ~45 min since the last one
FAN0 wired and jumpered for 24 V, the bay closed, the machine on and Ready with the exhaust fan still. Klipper does not know the fan yet.
Source: Ch 00a Step 00a.11 · Ch 13 Step 13.3