Skip to content
Batch B012 / 8

Step B01.2 — Load plate B01-P1

Step 2 of 8 with a helper · Batch B01 — Z drive assemblies

Parts:

  • z_drive_main_a ×2
  • z_drive_main_b ×2
  • z_drive_retainer_a ×1
  • z_drive_retainer_b ×2 — 15.2 h, 201 g (PrusaSlicer 2.9.6 estimate)

Do:

  1. Open slicer/plates/B01-P1.3mf with File → Open Project. Do not rebuild the plate.
  2. Confirm: profile 0.20mm STRUCTURAL @COREONE 0.4 (modified), 5 files, 7 objects, no brim outline.
  3. Do not change which face sits on the bed.

check Check

Estimated plate time is 15 h 13 m; if far off, re-verify profile/overrides before committing an overnight print.

helperHelper Reads the sorting diagram legend aloud and counts the parts on it while you load.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B01.8.

Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim

← PreviousStep B01.1 — Filament prep

Next →Step B01.3 — Pre-print checks