Batch B013 / 8
Step B01.3 — Pre-print checks¶
Step 3 of 8 · Batch B01 — Z drive assemblies
(no image — see text)
Do: Prepare the sheet per 00-slicer-setup § Print sheet with the glue film renewed, confirm the spool is dry, and start the chamber preheating.
Check
Chamber reads ≥40 °C before purge; Settings → Chamber Filtration reads Adv. Filtration.
Source: 00-slicer-setup § Print sheet · 00-slicer-setup § Calibration sequence · Prusa KB — ASA