Batch B023 / 9
Step B02.3 — Print plate B02-P1¶
Step 3 of 9 · Batch B02 — Accent parts (blue)
(no image — see text)
Do: Print with standing overrides, no brim on this plate's parts.
Check
Before start, Settings → Chamber Filtration reads Adv. Filtration. First layer clean; SB body prints without support failure.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced