Batch B033 / 5
Step B03.3 — Print plate B03-P1¶
Step 3 of 5 · Batch B03 — A/B drive units + front idlers
(no image — see text)
Do: Print with standing overrides.
Check
Before start, Settings → Chamber Filtration reads Adv. Filtration. No warp at drive-frame corners.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced