Skip to content
Batch B045 / 6

Step B04.5 — Inspect

Step 5 of 6 · Batch B04 — XY joints + X carriage

(no image — see text)

Do:

  1. Now: caliper each xy_joint_*_MGN12 half's four M3 holes, 3.40 mm, 15.0 × 16.0 mm apart.
  2. Now: caliper the carriage halves' M3 holes, 3.40 mm.
  3. Kit day: offer the real MGN12 carriage up before any heat-set.

check Check

Every M3 hole reads 3.40 mm ±0.10 and the two carriage halves close with no gap.

pause Good stopping point · ~10 min since the last one

holes calipered and the halves separated again; no inserts set, and the real carriage is a kit-day row (Ch 05 sets the inserts).

Source: print plan §5.2 — checkpoint after each batch · 00-slicer-setup § Calibration sequence · LDO Build Notes / FAQ

← PreviousStep B04.4 — Print

Next →Step B04.6 — Sort into bins