Skip to content
Batch B071 / 7

Step B07.1 — Filament prep

Step 1 of 7 · Batch B07 — Electronics bay + lighting

(no image — see text)

gather Gather for this segment — steps B07.1–B07.3 (~5 min)

Hardware

  • 8 files, 14 objects — 7.9 h, 102 g (PrusaSlicer 2.9.6 estimate)

Printed parts

  • wago_221-415_mount_3by5 — from bin 09-bay
  • lrs_200_psu_bracket_x2 ×2 — from bin 09-bay
  • PSU_stabilizer_50mm — from bin 09-bay
  • usb_adapter_mount — from bin spare-alt
  • usb_adapter_mount_partial_cover (ground-lug mount, est.) ×1 — from bin 08-CW2
  • pcb_din_clip_x3 ×3 — from bin 09-bay
  • handlebar_spacer_x4 ×4 — from bin 11-finish
  • power_inlet_IECGS_1mm — from bin 09-bay
  • 3 mm brim on wago_221-415_mount_3by5 and power_inlet_IECGS_1mm (the long-flat list), already in the project — from bin 09-bay

Do: Galaxy Black, spool #2 after B06. The ledger has 652 g on it here, 550 g after P1 and 426 g after P2, so no runout in this batch. Sheet per 00-slicer-setup § Print sheet.

check Check

Clean purge; ≥226 g on spool #2 for the two plates.

Source: print plan §4.3 — spool changes · 00-slicer-setup § Drying · Prusa KB — ASA

← PreviousBatch B07 — before you start

Next →Step B07.2 — Load plate B07-P1