Batch B073 / 7
Step B07.3 — Print plate B07-P1¶
Step 3 of 7 · Batch B07 — Electronics bay + lighting
(no image — see text)
Do: Print with standing overrides.
Check
Before start, Settings → Chamber Filtration reads Adv. Filtration. Clean first layer across the inlet's full 118 mm; no corner lift.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced