Step B07.4 — Load plate B07-P2¶
Step 4 of 7 with a helper · Batch B07 — Electronics bay + lighting
Gather for this segment — steps B07.4–B07.5 (~5 min)
Hardware
- 3 mm brim on the six 100 mm mounts, already in the project (long-flat brim list), none on the two 50 mm mounts
Printed parts
cob_light_strip_mount_100mm×6 — from bin 10-lightscob_light_strip_mount_50mm, eight mounts total, each a 2-piece assembly — 8.1 h, 124 g (PrusaSlicer 2.9.6 estimate) ×2 — from bin 10-lights
Parts:
-
cob_light_strip_mount_100mm×6 -
cob_light_strip_mount_50mm×2, eight mounts total, each a 2-piece assembly — 8.1 h, 124 g (PrusaSlicer 2.9.6 estimate) - 3 mm brim on the six 100 mm mounts, already in the project (long-flat brim list), none on the two 50 mm mounts
Do: Open slicer/plates/B07-P2.3mf with File → Open Project. The arrangement, brims and overrides
are already in it. Confirm it loaded as described rather than rebuilding it.
Check
Brim outline on the six 100 mm mounts only; eight mounts on the plate and nothing else.
Helper Names the bin colour of each part on the sorting diagram while you open the project.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B07.7.
Source: print plan §3 — the batches · 00-slicer-setup § Committed projects · 00-slicer-setup § Orientation & brim · LDO COB light-strip README · Prusa KB — Warping