Batch B075 / 7
Step B07.5 — Print plate B07-P2¶
Step 5 of 7 · Batch B07 — Electronics bay + lighting
(no image — see text)
Do: Print with standing overrides.
Check
Watch for end-lift on the 100 mm mounts partway through: this is the batch's known warp risk.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced