Batch B083 / 11
Step B08.3 — Print plate B08-P1¶
Step 3 of 11 · Batch B08 — Skirts and front modules
(no image — see text)
Do: Print with standing overrides.
Check
Before start, Settings → Chamber Filtration reads Adv. Filtration. Watch the ends of rear_center_skirt_350 for the first hour: 182 mm is the worst warp candidate.
Tip
look at the first layer, the corners after an hour, and at bedtime. A lifted corner is a stop. Paused or stopped: When the printer stops.
Good stopping point · ~5 min since the last one
plate started; nothing to do until it finishes. Meanwhile: read the chapter this batch feeds, sort the previous plate, label bins.
Source: 00-slicer-setup § Overrides · print plan §4.1 — how these numbers were produced