Step B11.14 — Sort the after-kit plates into bins¶
Step 14 of 14 with a helper · Batch B11 — Bay ducting (PETG V0)
(no image — see text)
Do: Snap each lid on once, then sort off the diagrams: bodies to 09-ducts-DC or 09-ducts-AC, lids to 10-lids-AC or 11-lids-DC.
Check
P4 sorted 6, 3, 3 and 6 into 09-ducts-DC, 09-ducts-AC, 10-lids-AC and 11-lids-DC; P5 or the fallback into the DC two.
Helper Reads each bin label aloud and checks the count against the diagram.
B11-P4
| bin | parts off this plate |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | V2L_58mm_DUCT ×3, V2L_130mm_DUCT, V2L_70mm_DUCT, V3L_10mm_DUCT |
| 09-ducts-AC — AC conduit, B11 | V3L_10mm_DUCT ×2, V3L_34mm_DUCT_HOLE |
| 10-lids-AC — AC lids + strip fin, B11 | V3L_10mm_DUCT_COVER ×2, V3L_34mm_DUCT_COVER |
| 11-lids-DC — DC lids, B11 | V2L_58mm_DUCT_COVER ×3, V2L_130mm_DUCT_COVER, V2L_70mm_DUCT_COVER, V3L_10mm_DUCT_COVER |
B11-P5
| bin | parts off this plate |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | V3L_154N_DUCT ×2, V3L_T_REG_N ×2 |
| 11-lids-DC — DC lids, B11 | V3L_154N_DUCT_COVER ×2, V3L_T_REG_N_COVER ×2 |
Fallback, printed instead of B11-P5 (gap under 25 mm)
| bin | parts of the fallback |
|---|---|
| 09-ducts-DC — DC conduit + coupon, B11 | CMD_V3_1H_T_REG ×2, CMD_V3_1H_82mm_DUCT |
| 11-lids-DC — DC lids, B11 | CMD_V2_6B_T_REG_COVER ×2, CMD_V2_6B_82mm_DUCT_COVER |
Before the next ASA plate
smooth sheet back on, and Settings → Chamber Filtration reads Adv. Filtration. On None the AFS blower never runs and ASA vents unfiltered.
Good stopping point · ~10 min since the last one
all of B11 is binned for Ch 09. Smooth sheet back on, Chamber Filtration on Adv. Filtration.
Source: print/README § Bins