Step B11.3 — Load and print plate B11-P1¶
Step 3 of 14 · Batch B11 — Bay ducting (PETG V0)
Parts:
-
V3L_COUPON_22N_DUCT -
V3L_COUPON_22N_DUCT_COVER - 2 files, 2 objects — 0.4 h, 4 g (PrusaSlicer 2.9.6 estimate)
- no brim
Do: Open slicer/plates/B11-P1.3mf with File → Open Project and print it on its own, first. It is the lid-snap test for the narrowed middle run.
Check
Preview shows the bay-ducts PETG V0 bundle, the duct base down and the lid flat, no supports.
What you're looking at
Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B11.8.
GUI QC pending
this arrangement came from nest.py. Before the first print, run Arrange Current Bed, save over the 3MF, then build_plates.py --from-3mf B11-P1 and check_docs.py.
Tip
Paused or stopped mid-plate? See When the printer stops.
Good stopping point · ~5 min since the last one
the coupon is printing, 25 min, textured sheet on.
Source: print/README § B11 · 00-slicer-setup § Committed projects · review/2026-09-23-bay-mods/layout-v3/layout-v3.md § Middle run