Skip to content
Batch B11 › Before kit5 / 14

Step B11.5 — Load and print plate B11-P2

Step 5 of 14 · Batch B11 — Bay ducting (PETG V0)

gather Gather for this segment — step B11.5 (~5 min)

Hardware

  • 6 files, 10 objects — 6.9 h, 96 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Printed parts

  • CMD_V3_1H_154mm_DUCT ×2 — from bin 09-ducts-DC
  • CMD_V2_6B_154mm_DUCT_COVER ×2 — from bin 11-lids-DC
  • CMD_V3_1H_90DEG ×2 — from bin 09-ducts-DC
  • CMD_V2_6B_90DEG_COVER ×2 — from bin 11-lids-DC
  • V2L_90DEG_MIRROR — from bin 09-ducts-DC
  • V2L_90DEG_COVER_MIRROR — from bin 11-lids-DC

Parts:

  • CMD_V3_1H_154mm_DUCT ×2
  • CMD_V2_6B_154mm_DUCT_COVER ×2
  • CMD_V3_1H_90DEG ×2
  • CMD_V2_6B_90DEG_COVER ×2
  • V2L_90DEG_MIRROR
  • V2L_90DEG_COVER_MIRROR
  • 6 files, 10 objects — 6.9 h, 96 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Do: Open slicer/plates/B11-P2.3mf with File → Open Project. This is the DC conduit's front run and its three corners.

check Check

Every duct body base down, every lid flat; the two 154 mm ducts lie clear of the bed edge.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B11.8.

tip Tip

Paused or stopped mid-plate? See When the printer stops.

pause Good stopping point · ~5 min since the last one

plate B11-P2 running, 6.9 h unattended.

Source: print plan §3 — the batches · MSS duct remix, Printables 502306

← PreviousStep B11.4 — Test the coupon's lid snap

Next →Step B11.6 — Load and print plate B11-P3