Skip to content
Batch B11 › Before kit6 / 14

Step B11.6 — Load and print plate B11-P3

Step 6 of 14 · Batch B11 — Bay ducting (PETG V0)

gather Gather for this segment — step B11.6 (~5 min)

Hardware

  • 10 files, 15 objects — 4.6 h, 73 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Printed parts

  • V3L_WIRE_BOX_PORT — from bin 09-ducts-AC
  • CMD_V2_6B_WIRE_BOX_COVER — from bin 10-lids-AC
  • V3L_90DEG_R15 ×2 — from bin 09-ducts-AC
  • V3L_90DEG_R15_COVER ×2 — from bin 10-lids-AC
  • CMD_V3_1H_T_SHORT — from bin 09-ducts-AC
  • CMD_V2_6B_T_SHORT_COVER — from bin 10-lids-AC
  • CMD_Remix-V3_DUCT-1M_ENDCAP ×2 — from bin 09-ducts-AC
  • V2L_STRIP_FIN — from bin 10-lids-AC
  • CMD_Remix-V3_DUCT-2B_45deg ×2 — from bin 09-ducts-DC
  • CMD_Remix-V3_DUCT-2B_45deg_LID ×2 — from bin 11-lids-DC

Parts:

  • V3L_WIRE_BOX_PORT
  • CMD_V2_6B_WIRE_BOX_COVER
  • V3L_90DEG_R15 ×2
  • V3L_90DEG_R15_COVER ×2
  • CMD_V3_1H_T_SHORT
  • CMD_V2_6B_T_SHORT_COVER
  • CMD_Remix-V3_DUCT-1M_ENDCAP ×2
  • V2L_STRIP_FIN
  • CMD_Remix-V3_DUCT-2B_45deg ×2
  • CMD_Remix-V3_DUCT-2B_45deg_LID ×2
  • 10 files, 15 objects — 4.6 h, 73 g (PrusaSlicer 2.9.6 estimate)
  • no brim

Do: Open slicer/plates/B11-P3.3mf with File → Open Project. This is the AC conduit, the strip fin and the DC S-jog.

check Check

Endcaps stand on their flat face, the fin lies plate down, every duct body sits base down.

What you're looking at

Sorting diagram, drawn from the committed project: every part numbered and filled in the colour of its bin, bin id on the part; the legend reads # · STL · bin (chapter · steps). Sort at Step B11.8.

tip Tip

Paused or stopped mid-plate? See When the printer stops.

pause Good stopping point · ~5 min since the last one

plate B11-P3 running, 4.6 h unattended.

Source: print plan §3 — the batches · MSS duct remix, Printables 502306

← PreviousStep B11.5 — Load and print plate B11-P2

Next →Step B11.7 — Inspect the before-kit plates